Troubleshooting
Symptom Causeand/or Corrective Actions
The melody o1"heep sounds for • Moisture condensation has occtnred.
5 seconds. ") Remove tile cassette and leave your camcorder for at
least one hour to acclimatize. (p. 152)
• Some troubles has occurred in your camcorder.
") Remove the cassette and insert it again, then operate
your camcorder.
While charging tile battery pack, the • Charging is completed. (p. 11)
CHARGE lamp doesn't flash. • The batte W pack is not properly installed.
") Install it properly.
• Sonmthing is wrong with tile battelT pack.
") Contact your Sony dealer or local authorized Sony
service fhcility.
You cannot charge the battery pack. • The POWER switch is not set to OFF (CHG).
+ Set it to OFF (CHG).
While charging tile battery pack, the • The batte W pack is not properly installed.
CHARGE lamp flashes. ") Install it properly.
• Something is wrong with tile batte W pack.
") Contact your Sony dealer or local authorized Sony
service fhcility.
The power goes off although the • Charge tile batte W pack fully again so that the indication
battery remaining indicator indicates on the battery remaining indicator is correct.
that tile battery pack has enough
power to operate.
No flmction works though tile power • Disconnect tile power cord of the AC power adaptor o1"
is on. remove tbe battery, then reconnect it ill about one minute.
Turn tile power on. If the flmctions still do not work, open
the LCD panel and press the RESET button under S
VIDEO jack using a sharp pointed object. (Ifyou press tile
RESETbutton, all tile settings including tile date and time
return to the defhult.) (p. 161)
• Your camcorder is not a malfunction.When you set tile POWER switch to
VCR or OFF (CHG). if you move
your camcorder, you may hear a
clatter sound from inside your
camcorder.
>
{D.
o
147
To Next Page
