7-44
DSR-2000A/2000AP
P1.4 x 3.5
Flexible card wire
Rail assembly
Phase determining hole
Phase determining hole
Mode gear
No.3 gear
Manual eject
cover
Phase
determining
hole
(2) Turn the manual eject cover clockwise and
align the two phase determining holes in the
mode gear assembly and in No.3 gear.
(3) Remove the three screws and remove the rail
assembly.
n
Use extreme care not to scratch the drum and
the tape guide when removing. Also great
care should be taken; not to fold and not to
scratch the flexible card wire of the LED
holder assembly when disconnecting.
To Next Page
Loading...
