Sony DSR-2000A - Installation Setup and Adjustment; Switch Settings on the Connector Panel

2-10
DSR-2000A/2000AP
2-9. Installation Setup and Adjustment
2-9-1. Switch Settings on the Connector Panel
When the unit is installed, be sure to perform the following setup and adjustment. If the adjustment is not
performed, the unit may not operate properly.
Refer to the operating instruction “Chapter 1 Overview” for setup and adjustment.
[Connector Panel]
(1) The setting of 75 Z termination switch :
REF VIDEO 75 Z ON/OFF
ON : When the line is terminated in this unit.
OFF : When another unit is connected with this unit.
(2) The setting of video input termination switch :
VIDEO INPUT 75 Z ON/OFF
ON : When the line is terminated in this unit.
OFF : When another unit is connected with this unit.
(3) The setting of audio input level select switch :
+4 dBm : +4 dBu reference level on output side
0 dBm : 0 dBu reference level on output side
_6 dBm : _6 dBu reference level on output side