Help Guide
IC Recorder
ICD-TX800
Recording automatically in response to the input sound volume – the VOR function
You can set your IC recorder to automatically start when the input sound volume reaches the predefined level, and
pause when the volume decreases below the level.
Operate the remote control and follow the steps below:
When the input sound volume decreases below the predefined level, “VOR” on the display window of the IC recorder
flashes and the recording pauses. When the volume reaches the level once again, the recording restarts.
Note
The VOR function is affected by the ambient sound conditions. Select the sensitivity level of the built-in microphones suitable to
your ambient sound conditions. For instructions on selecting the sensitivity level, see Selecting the sensitivity level of the
microphones (Mic Sensitivity).
If the selected sensitivity level does not work as you expected or when you want make an important recording, follow the above
steps to set “VOR” to “OFF.”
Hint
To cancel the VOR function setup process, set “VOR” to “OFF” in step 2.
4-699-323-32(1) Copyright 2017 Sony Corporation
Operate the remote control to select “
Settings” - “Recording Settings” - “VOR” from the HOME menu,
and then press
.
1
Press
or to select “ON,” and then press .
“VOR” is set to “OFF” by default.
2
Press
REC.
“VOR” and
appear on the display window.
3
To Next Page
Loading...
