Sony ICP-X7000

11
Directory Operations ..............................386
Creating a Directory ..................................386
Renaming a Directory ...............................386
Protecting (Write Inhibit) a Directory .......386
Deleting a Directory ..................................387
Copying Files Between Unit IDs ............387
Copying Files Between Different Unit
IDs....................................................387
Chapter 17 System Setup
Settings Relating to the Network...........388
Setting the Group ID and Unit ID of the
Menu Panel ......................................388
Configuring the NFS Server......................388
Initializing Network Interface Settings .....389
Setting the Network Connector Board Service
Port...................................................389
Configuring a Network Interface ..............389
Setting the Network Interface Protocol .....393
Settings Relating to System
Configuration....................................394
Selecting the Operation Mode...................394
Specifying the Switcher Controlled by the
Control Panel ...................................394
Specifying the DME Used on the
Switcher ...........................................395
Settings Relating to Signal Formats .....395
Setting the Signal Format..........................396
Setting the OETF and Color Gamut..........396
Enabling Passage of 59.94 (2×) Format
Signals on an AUX Bus ...................397
Switching the Input Reference Signal .......397
Adding a Payload ID .................................397
Setting the Screen Aspect Ratio ................398
Power-On (Startup) State Selection ......398
Saving and Recalling Setup Data ..............399
Selecting the Startup State.........................399
Saving User-Defined Settings ...................400
Restoring Initial Status File Settings.........400
Reset and Initialization ...........................400
Settings Relating to Installation and
Devices.............................................. 401
Displaying Installation Detail
Information ......................................401
Installing Software ....................................401
Configuring Settings to Use the
Software ...........................................401
Settings Relating to Device
Management ..................................... 403
Setting the Date and Time .........................403
Using a Removable Drive .........................403
Setting a Removable Drive as the Primary
Device ..............................................404
Initializing the Local Drive .......................404
Locking Setup Menu Settings ...................404
Locking File Loading Operations..............405
Enabling/Disabling SDI Output
Connectors .......................................405
Chapter 18 Control Panel Setup
Settings Relating to Control Panel
Configuration.................................... 407
Setting the Configuration for Each
Bank .................................................407
Inhibiting Operation on a Bank .................407
Assigning a Single M/E to Two M/E
Banks................................................407
Linking Switcher Bus and Router
Destinations......................................408
Linking Transitions Between Keyers ........409
Setting the Buttons and Fader Levers on the
Key Fader Control Block .................409
Assigning a Region to the Region Selection
Buttons in the Numeric Keypad Control
Block ................................................410
Setting Transition Control Block Button
Assignments.....................................411
Setting Independent Key Transition Control
Block Button Assignments ..............411
Setting Flexi Pad Control Block Button
Assignments.....................................411
Setting Utility/Shotbox Control Block Button
Assignments.....................................412