193
The enable/disable setting is applied to all link groups.
1
Open the Aux >Aux Bus >CCR menu (2311).
2
Press [Link Enable] to enable/disable link groups.
To enable, press [Link Enable], turning it on. To
disable, press [Link Enable], turning it off.
To apply the same setting to color correctors in
the group
If the setting of color correctors in the group is different,
select a specific AUX bus and press [Copy in Link]. The
color corrector of all AUX buses in the group are set to the
same setting as the selected AUX bus.
Status Menu
You can check the state of DME usage in the Status menu.
Displaying DME usage status
Open the Status >DME Status menu (3311).
The usage status for each DME channel is displayed.
You can check the following status according to the
background color of the display.
Blue: The DME is currently being used in other than the
final program output.
Red: The DME is currently being used in the final
program output.
Note
DME usage status display
To Next Page
Loading...
