36
Key Control Block
The key control block is used to adjust and modify keys.
a Delegation buttons
These select the bank (M/E and PGM/PST) and keyer to
assign to the key control block.
BANK SEL (bank
select)
Switches the memory recall section
to numeric keypad mode for
entering bank numbers.
Enter a bank number and press the
[ENTER] button to switch the
memory recall section to the
register display for the selected
bank.
Button name Description
f Display
g Adjustment
knobs
b DME channel selection
buttons
a Delegation buttons
e Function buttons
c ON AIR indicators
d Setting buttons
Button name Description
M/E1 to M/E5, P/P Assigns M/E-1 to M/E-5 banks and
PGM/PST bank.
KEY1 to KEY8 • Assigns key 1 to key 8.
• Press and hold a [KEY1] to
[KEY8] button and press an
[M/E1] to [M/E5] or [P/P] button
to return the settings of the
selected key to the defaults.
TRANS (transition) • Used to check the DME channel
used for DME wipes on the M/E
or PGM/PST bank.
• You can select the DME channel
to be used beforehand when a
DME wipe is selected as the
transition type.
• Press and hold the [TRANS]
button and press a [KEY1] to
[KEY8] button to enable
independent key transition
operation.
SUB TRANS (sub
transition)
In Multi Program 2 mode, used as
the [TRANS] button on the sub
side.
For details about Multi Program 2
mode, see “Multi Program 2”
(page 200).
Button name Description
To Next Page
Loading...
