- 6 -
AE-6D SELF DIAGNOSTIC SOFTWARE
The identification of errors within the AE-6D chassis is triggered in one of two ways :- 1: Busy or 2: Device failure to respond to IIC. In the
event of one of these situations arising the software will first try to release the bus if busy (Failure to do so will report with a continuous
flashing LED) and then communicate with each device in turn to establish if a device is faulty. If a device is found to be faulty the relevant
device number will be displayed through the LED (Series of flashes which must be counted) See table 1., non fatal errors are reported using this
method.
Flash Timing Example : e.g. error number 3
StBy LED
ON
ON ON
OFF
OFF
metIcitsongaiD
noitpircseD
ybdnatSsemitfooN
sehsalFDEL
esuacelbaborP
noitacoL
smotpmySdetceteD
nonruttonseodrewoPthgiltonseoD
.nideggulptonsidrocrewoP
.tiucricneposiesuF
noemoctonseodrewoP
VTehtotdeilppussirewopoN
ytluafsiylppusrewopCA
)PCO(tnerrucrevOB+semit2
.)draoBD(detrohssi)4088/3088Q(TUO.H
.)draoBD(detrohssi)6088Q(TEFytiraeniL
noemoctonseodrewoP
detrohssahenilrewopnodaoL
deppotsnoitcelfeDlacitreVsemit4
)draoBD(nepo5388RdeilppustonsiV51+
)draoBD(nepo4388RdeilppustonsiV51-
)draoBA(detrohssi1071CI
deppotssaheslupnoitcelfedlacitreV
detrohssahenilrewoP
egasseMrorrE
DEL
edoC
rorreoN00
devreseR10
)noitcetorPtnerruCrevO(PCO20
)noitcetorPegatloVrevO(PVO30
noitcetorPlacitreV40
)sces03retfastratskcehc(BKAelbatsnU50
noitcetorPlatnoziroH60
noitcetorPrekaepS70
rorre0subC2I80
redoceD-txeT-eleTB-M90
MVN,23C42TSB-M01
redoceDruoloCniaM,0239ADTB-J11
dnekcaBQ0512AXCB-A21
rossecorPdnuoS,D0143PSMB-A31
orciMlatigiDAMMEB-N41
MARlanretxE81
To Next Page
Loading...
