78
GB
Enter the frequency of a station directly by
using the numeric buttons.
1 Connect a TV monitor to this
receiver.
Refer to “3: Connecting the monitor for
displaying menus” (page 19).
2 Turn on the receiver and the TV.
3 Press RECEIVER to enable
receiver operation.
4 Press ON SCREEN.
The menu list of this receiver appears on
the TV screen. Press MENU if the menu
list does not appear on the TV screen.
5 Press V/v repeatedly to select
“FM” or “AM,” then press or
b.
6 Press OPTIONS.
7 Press V/v to select “Direct
Tuning,” then press .
8 Press the numeric buttons to
enter the frequency, and then
press to enter.
Example 1: FM 102.50 MHz
Select 1 b 0 b 2 b 5 b 0
Example 2: AM 1,350 kHz
Select 1 b 3 b 5 b 0
9 Press .
Tip
If you have tuned in an AM station, adjust
the direction of the AM loop antenna
(aerial) for optimum reception.
If you cannot tune in a station
and the entered numbers flash
Make sure you have entered the right
frequency. If not, repeat steps 8 to 9. If you still
cannot tune in a station, the frequency is not
used in your area.
Direct tuning
5
3
8
2
6
5,
7-9
MENU
4
To Next Page
Loading...
