• SB XXXX
(Surround back decoding mode)
You can use the CUSTOMIZE menu to set the
surround back decoding mode (page 34)
For details on each decoding mode, see page 35
• SB AUTO
• SB MTRX
• SB OFF
Note
This paiame_er is valid only m the AFD. mode
(page 31 )
• S.F XXXX (Sound field link)
• S.F LINK
Lets you apply the last selected sound field to an
input whenever it is selected. For example, if you
select HALL tbr the CDiSACD input, then change to
a different input and return to CD/SACD, HALL will
automatically be applied again.
• S.F FIX
Sound field link is not activated.
• DEC. XXXX
(Digital audio input decoding priority)
Lets you specif}, the input mode foi the digital signal
input to the DIGITAL IN jacks.
The initial setting is "DEC. AUTO" tbr VIDEO 3 and
TViSAT, and "DEC PCM" for DVD and MDiTAPE
• DEC AUTO
Automatically switches tile input mode between
DTS, Dolby Digital, or PCM.
• DEC PCM
PCM signals are given priority (to prevent the
intenuption when playback stails) Even when othei
signals are input, the sound is output However, this
receiver cannot decode DTS-CD when set to "DEC
PCM'. When set to "DEC. AUTO" and the sound
from the digital audio jacks (for CD, etc.) is
intemtpted when playback stairs, set to "DEC.
PCM"
• D.PWR. XXXX
(Digital power management)
• D PWR OFF
Lets you turn off the powei of the tmnecessal T digital
circuits automatically when outputting the analog
audio signals using the ANALOG DIRECT or
MULTI CH IN fimction You can enjoy high quality
analog audio without the influence of digital circuits.
• D.PWR. ON
Lets you keep the power of digital circuits on Select
if you do not like tile time lag that occurs with file
"D.PWR. OFF" setting.
• PWR.S. XXX
(CONTROL Al: Power link)
• PWRS ON
The power link fimction is not activated, but you can
declease the powei consumption of tile receiver
dming standby mode.
• PWRS OFF
Lets you turn on tile system automatically when tile
component connected via CONTROL AI colds
(page 45) is turned on
• COAX-XXX
(Coaxial Input Assignment) _>
• DVD e_
<
Lets you assign the COAXIAL input jack to DVD Da
input. O
• CD e,
Lets you assign the COAXIAL input jack to CD _>
SACD inpuL c
• [DIMMER]
Lets you adjust tile brighmess o/'tlle display
• NAME IN _"
(Naming preset stations and inputs)
Lets you set the name of preset stations and inpms e_
(/)
selected with INPUT SELECTOR. For details, see ¢t_
"Naming preset stations and inputs" on page 42. :::1:_,
(,O
0_
Advanced SP SETUP menu
parameters
When "MENU" is set to "MENU EXP.', all of
the following parameters are displayed and
acliustable.
See page 20 l_r the SP SETUP menu
acliustments. Initial settings are underlined.
continued_
39G8