Operation
28
• The centrifuge must be protected from heat and
direct sunlight.
• The location must be well ventilated at all times.
UV rays reduce the durability of
plastics.
Protect the centrifuge, rotors and
plastic accessories from direct
sunlight.
Main connection
Connect the centrifuge only to an grounded main
power supply. Make sure that the power cord is com-
patible with the safety regulations valid, and that your
main voltage and frequency correspond to the speci-
fications on the instrument label.
Make sure that the centrifuge is switched off (on the
right-hand side of front panel) before connecting
electrical wire to main power supply.
Main connection
specifications
RS232 interface
(optional)
To Next Page
Loading...
