What to do if Sorvall Laboratory Equipment displays error E-39?
If your Sorvall Laboratory Equipment displays error code E-39, switch the instrument off and on again. If the error persists, contact KENDRO service.
What to do if Sorvall Laboratory Equipment is too noisy?
If your Sorvall Laboratory Equipment is making excessive noise, immediately press the "stop" key, or unplug the mains power cord in an emergency. Wait for the centrifuge to stop completely. Then, check if the rotor is loaded correctly and look for any broken tubes or damage to the rotor or motor that might be causing the noise.
What to do if Sorvall Legend RT Laboratory Equipment displays message "bAl"?
If the message "bAl" appears on the display of your Sorvall Laboratory Equipment, open the instrument by pressing the "open lid" key. Then, check to ensure the rotor is properly loaded, and inspect for any broken tubes or rotor damage that may have triggered the imbalance switch. Also, verify that the trunnions of the swinging bucket rotor are properly lubricated.
What to do if Sorvall Legend RT Laboratory Equipment displays message “Lift Lid“?
If the message "Lift Lid“ appears in the display of your Sorvall Laboratory Equipment, avoid placing any objects on the centrifuge lid and try lifting the lid slightly.
What to do if Sorvall Legend RT displays message "Lid"?
If the message "Lid" is flashing in the display of your Sorvall Laboratory Equipment, and the lid was opened manually during operation, switch the instrument off and then on again to continue the run.
What to do if Sorvall Legend RT Laboratory Equipment displays error E-22 or E-23?
If your Sorvall Laboratory Equipment displays error code E-22 or E-23, switch the instrument off and on again. If the error persists, contact KENDRO service.
What to do if Sorvall Legend RT displays error E-15 or E-16?
If your Sorvall Laboratory Equipment displays error code E-15 or E-16, switch the instrument off and on again. If the problem persists, contact KENDRO service.
What to do if Sorvall Legend RT Laboratory Equipment displays error E-17?
If your Sorvall Laboratory Equipment displays error code E-17, switch the instrument off and on again. If the problem persists, contact KENDRO service.
What causes error E-21 on Sorvall Laboratory Equipment?
To address error E-21 on your Sorvall Laboratory Equipment, first check if a certified rotor is inserted. If the error occurred after a brief power failure, switch the instrument off and on again using the main switch.
What to do if Sorvall Laboratory Equipment displays error E-33?
If your Sorvall Laboratory Equipment displays error code E-33, turn the instrument off and pull the main plug. Inspect and clean the ventilation slots if necessary. After about 60 minutes, you can restart the instrument, ensuring you observe the maximum permissible environmental temperature.
Details incorrect handling that can cause harm or damage.
Safety guidelines for handling dangerous substances.
Details the built-in safety features designed to protect users and the instrument.
Comprehensive list of the centrifuge's operational capabilities and advanced functions.
Procedures and precautions for moving and setting up the centrifuge.
Criteria for selecting a suitable and safe operating environment.
Instructions for correctly connecting the centrifuge to the power supply.
Procedure for manually opening the lid during power failure.
Guide to diagnosing and resolving instrument error codes.
Information on how to get technical support from the manufacturer.
General| Type | Benchtop centrifuge |
|---|---|
| Maximum Speed | 15, 000 rpm |
| Temperature Range | -10°C to +40°C |
| Programs | 99 |
| Timer | Up to 99 hours |
| Power Requirements | 50/60 Hz |
| Acceleration Time | ≤ 20 seconds |
| Deceleration Time | ≤ 20 seconds |
| Noise Level | ≤ 60 dBA |
To Next Page
