Operation
54
Audible alarm
Accompanying all error messages, a warning signal
is given out which only is silenced upon pressing any
key.
As an option, you can also have the end of a run
signaled acoustically. To activate or deactivate this
option press the program key and switch on the
centrifuge simultaneously. As far as you keep the
key pressed, the selective mode is active.
The speed panel shows "beep“ and the time panel
shows "on“ or "off“.
By actuating the upward-key
in the time panel the
signal function can be switched on or off
.
When the message "rotor“ flashes, press-
ing the start key once is sufficient to turn off
the warning signal and to accelerate the
rotor to the maximum speed displayed by
the instrument.
Turning the centrifuge off
By switching the main switch into "0“ position the
centrifuge is turned off.
The main power switch should be turned off
after a complete centrifugation run. Without
motor deceleration, it takes much more time
until the rotor comes to a halt.
The centrifuge lid can only be opened automatically if
the centrifuge is turned on!
To Next Page
Loading...
