What to do if Sorvall Legend RT displays error E-14?
If your Sorvall Laboratory Equipment displays error code E-14, switch the instrument off and on again. If the error persists, contact KENDRO service.
What to do if Sorvall Laboratory Equipment displays error E-01 or E-13?
If your Sorvall Laboratory Equipment displays error code E-01 or E-13, switch the instrument off and on again. If the error persists, contact KENDRO service.
What to do if Sorvall Laboratory Equipment displays error E-34?
If your Sorvall Laboratory Equipment displays error code E-34, switch the instrument off and on again.
How to open the lid of Sorvall Legend RT?
If the lid of your Sorvall Laboratory Equipment won't open, first ensure the main power is on and the instrument display is lit. If it is, press down on the middle of the front section of the lid and then press the "open lid" key. As a last resort, use the emergency lid release.
What causes error E-18 on Sorvall Legend RT Laboratory Equipment?
To fix error E-18 on your Sorvall Laboratory Equipment, verify that the bucket is approved for use with the inserted rotor.
What causes error E-21 on Sorvall Laboratory Equipment?
To address error E-21 on your Sorvall Laboratory Equipment, first check if a certified rotor is inserted. If the error occurred after a brief power failure, switch the instrument off and on again using the main switch.
What causes error E-20 on Sorvall Laboratory Equipment?
To resolve error E-20 on your Sorvall Laboratory Equipment, first check if a certified rotor is inserted. Then, ensure the rotor is completely fastened onto the motor shaft by releasing the rotor fastening until you can easily lift and depress it, and then re-tighten the fastening.
What to do if Sorvall Laboratory Equipment displays error E-33?
If your Sorvall Laboratory Equipment displays error code E-33, turn the instrument off and pull the main plug. Inspect and clean the ventilation slots if necessary. After about 60 minutes, you can restart the instrument, ensuring you observe the maximum permissible environmental temperature.
What to do if Sorvall Legend RT displays error E-32?
If your Sorvall Laboratory Equipment displays error code E-32, turn the instrument off and unplug the mains power cord. Inspect and clean the ventilation slots if necessary. After about 60 minutes, restart the instrument, ensuring you observe the maximum permissible environmental temperature.
What to do if Sorvall Legend RT displays error E-31?
If your Sorvall Laboratory Equipment displays error code E-31, turn the instrument off and unplug the mains power cord. Inspect and clean the ventilation slots if necessary. After approximately 60 minutes, you can restart the instrument.
Details incorrect handling that can cause harm or damage.
Safety guidelines for handling dangerous substances.
Details the built-in safety features designed to protect users and the instrument.
Comprehensive list of the centrifuge's operational capabilities and advanced functions.
Procedures and precautions for moving and setting up the centrifuge.
Criteria for selecting a suitable and safe operating environment.
Instructions for correctly connecting the centrifuge to the power supply.
Procedure for manually opening the lid during power failure.
Guide to diagnosing and resolving instrument error codes.
Information on how to get technical support from the manufacturer.
General| Type | Benchtop centrifuge |
|---|---|
| Maximum Speed | 15, 000 rpm |
| Temperature Range | -10°C to +40°C |
| Programs | 99 |
| Timer | Up to 99 hours |
| Power Requirements | 50/60 Hz |
| Acceleration Time | ≤ 20 seconds |
| Deceleration Time | ≤ 20 seconds |
| Noise Level | ≤ 60 dBA |
To Next Page
