Operation
31
Handling the rotor
On swinging bucket rotors, at regular inter-
vals, apply a light coating of lubricant to the
rotor body trunnion pins and to the corre-
sponding mating surfaces on the buckets!
Lubricant 7000 6692 is supplied with the centrifuge.
Swinging Bucket Rotor 7500 6445
(7500 6434 with locking mechanism)
Do not operate the Swinging Bucket
Rotor 7500 6445 with the rectangular
buckets belonging to BIOshield
®
Rotors!
All positions have to be loaded with identi-
cal carrier buckets always!
The various swinging buckets are split up into weight
categories. These can be identified from the letters
suffixing the order number on the bucket. Buckets of
identical weight categories should always be in-
stalled in opposing positions to avoid imbalance.
Handling microplates
Remove the microplate holder from carrier to load
and unload the microplate carrier 7500 6449. Make
sure, before loading, that the rubber bottom is placed
in the cut-outs of the bottom of plate carrier. Deep-
well plates can also be inserted in the carrier without
using plate holder.
To Next Page
Loading...
