Speco D8HS - Page 80

80
o Primary SNTP Server: Input the NTP primary server address.
o Secondary SNTP Server: Input the NTP secondary server address.
o Time Zone: Select the time zone.
o Connection Mode: Select the connection mode to NTP time server.
 SEND E-Mail SETUP: Sets whether to enable/disable e-mail sending function.
o SEVER TYPE: Select GMAIL, HOTMAIL, AOL, YAHOO or MANUAL)
o MAIL SERVER: Input the SMTP server name as well as the user ID and password.
o MAIL PORT: Mail port setting.
o SEURE OPTION: Select a secure mail server connection. (SSL or TLS)
o ID : Email User ID
o PASSWORD : Email User Password
o MAIL TO: Input the appropriate email address to enable sending e-mail reports
o MAIL FROM (Return Mail Address): Set the source e-mail address to be notified to the
destination.
 SEND MAIL TEST : E-mail settings sent a test mail to the registered account
 UNIT NAME: Name the HS
 SYSTEM RESTART : Restart the system
 SYSTEM EVENT NOTIFICATION
Allows the user to set EVENT NOFICIATION ON or OFF
o HEALTH CHECK
(Allows the user to set MAIL STATUS periodically) : DAILY or WEELY or MONTHLY
o HDD TEMPERATURE
o HDD BAD SECTOR
o HDD ALMOST FULL
o VIDEO CLIP SETUP: Setting the duration for pre and post recording.
o EVENTS AND NOTIFICATION
o HEALTH CHECK / RESTART / SHUTDOWN / PANIC RECORD
Enable Email Notification in the event a problem occurs with the VS.
o ALARM-IN : Enable Email Notification when the camera detects sensor
o MOTION DETECTION : Enable Email Notification when the camera detects motion
o VIDEO LOSS : Enable Email, Beep and Alarm output Notification when the camera signal is
lost.
o HDD TEMPERATURE : Enable Email Beep and Alarm output Notification when the HDD
reaches the maximum temperature
o HDD BAD SECTOR : Enable Email Notification when the HDD has bad sectors.
o HDD ALMOST FULL : Enable Email Notification when the HDD is almost full.
o HDD FULL : Enable Email Notification when the HDD is full.
o HDD FAILURE : Enable Email, Beep and Alarm output Notification when the HDD fails.