Spohn & Burkhardt VCS0 - Page 65

65
Spohn + Burkhardt
3. Carefully pull the rubber boot (3) o the escutcheon (8)
4. Carefully remove the escutcheon (8) from the escutcheon holder (6) using a suitable tool (e.g.
at-bladed screwdriver).
5. Press together the rubber boot (3) and carefully pull the escutcheon (8) and the lm (7) over the
rubber boot (3).
6. Undo the 4 screws M4x14.
7. Press together the rubber boot (3) and pull the escutcheon holder (6), the seal (5) and the front
plate (4) over the rubber boot (3).
8. Open the installation space
Installation
1. Press together the rubber boot (3) and push the joystick VCS0 through the installation opening
from below.
2. Press together the rubber boot (3) and pull the front plate (4), the seal (5) and the escutcheon hold-
er (6) carefully over the rubber boot (3).
3. Fasten the joystick VCS0, the front plate (4), the seal (5) and the escutcheon holder (6) using the 4
screws M4x14.
4. Press together the rubber boot (3) and carefully pull the lm (7) and the escutcheon (8) over the
rubber boot (3).
5. Click the escutcheon (8) to the escutcheon holder (6).
6. Pull the rubber boot (3) over the escutcheon (8).
7. Make the electrical connection, see section5.2 "Electrical connection", page 69.
8. Close the installation space
9. Undertake setup as per chapter 6. "Setup", page 70.