Spohn & Burkhardt VCS0 - Servicing and Maintenance; Servicing Measures and Intervals; Visual Inspection and Cleaning

71
Spohn + Burkhardt
7. Servicing
Danger!
All tasks on the device are only allowed to be undertaken by specialist personnel taking
into account the relevant safety regulations. Always pay attention to the safety instruc-
tions in chapter 1. "Safety", page 53.
Servicing measure Interval
Visual inspection/cleaning/check screw joints for rm
seating
Monthly (
Spohn & Burkhardt recommendation); de-
pending on usage, more frequent checking may be
necessary.
Function test Before starting work
Grease moving parts Quarterly, or as required
Replace knob As required
Replace rubber boot As required
Replace contact elements As required
Replace cam disk As required
Adjust braking force/replace brake disc
(only for variants with friction brake)
Decreasing braking force
Table 1. Servicing measure and Intervalls
7.1. Visual inspection/cleaning
Danger!
Damaged joysticks VCS0 are not allowed to be operated.
1. Check the joystick VCS0 and its components for soiling.
• If necessary, remove any soiling.
2. Check the joystick VCS0 and its components for damage.
• Replace damaged joysticks VCS0 (see chapter 9. "Removal", page 79 and chapter 5. "Installation",
page 63).
• Replace damaged components.
3. Check all screw joints for correct seating.
• Tighten loose screw joints.
7.2. Function test
see chapter 6.1. "Function test", page 70