Spohn & Burkhardt VCS0 - Joystick VCS0 with Escutcheon Holder Installation

To Next Page

To Previous Page

Spohn + Burkhardt

5.1.2. Joystick VCS0… with escutcheon holder

Note

The following installation instructions apply to the basic version of the joystickVCS0:

• With potentiometer,

• With optoelectronic absolute encoder

• As well as the versions

• 96…; 72…; S…; and S0….

See also section 4.1 "Type codes", page 56 and Appendix A. "Examples for variants and

available ttings", page 89.

For installation instructions for other variants, contact

Spohn & Burkhardt GmbH & Co. KG

(for contact data see Imprint, page 2).

Note

The switch panel is allowed to be maximum 5mm thick.

Figure 8.

7; 8

Joystick VCS0 with escutcheon holder - installation

Preparatory work

1. Disconnect the system from the supply of electrical power.

2. Prepare the installation space, see Figure 7 "Joystick VCS0 …: dimensions of installation openings (di-

mensions in mm)", page 63.