Spohn & Burkhardt VCS0 - Greasing Moving Parts

72
Spohn + Burkhardt
7.3. Grease moving parts
The moving parts must be regularly greased using a suitable product, e.g. Interon Fine Assembly
Grease 8028, see Table 1. "Servicing measure and Intervalls", page 71.
Figure 12. Joystick VCS0 – greasing moving parts – schematic illustration
Preparatory work
1. Disconnect the system from the supply of electrical power.
2. Remove the joystick VCS0 as per chapter 9. "Removal", page 79.
3. Remove the switching elements as per section 7.6 "Replacing contact element", page 75.
Grease moving parts
1. Grease
• The roller,
• The roller groove,
• The detent and
• The pin
2. Install the switching elements as per section 7.6 "Replacing contact element", page 75.
3. Install the joystick VCS0 as per chapter 5. "Installation", page 63.