68
Spohn + Burkhardt
Installation
1. Press together the rubber boot (3) and push the joystick VCS0 with the boot holder escutcheon (21)
through the installation opening from below.
2. Fasten the joystick VCS0 with the boot holder escutcheon (6) to the mounting plate.
3. Pull the rubber boot (3) over the boot holder escutcheon (21).
4. Make the electrical connection, see section5.2 "Electrical connection", page 69.
5. Close the installation space
6. Undertake setup as per chapter 6. "Setup", page 70.
To Next Page
Loading...