Square QED-2 - Page 7

List of Figures Power-Style™ QED-2 Switchboards
5
ENGLISH
© 1988–2018 Schneider Electric All Rights Reserved80043-055-13
List of Figures
Figure 1 – Typical QED-2 Roof Hood Construction ............................................. 7
Figure 2 – Lifting with an Overhead Crane, Lifting Straps, and Cables or Chains .... 9
Figure 3 – Handling Instruction Label, Switchboards without Lifting Straps ...... 11
Figure 4 – Rear Warning Label, Rainproof Switchboards .................................. 12
Figure 5 – Front Warning Label, Rainproof Switchboards ................................. 12
Figure 8 – Belleville Washer .............................................................................. 19
Figure 9 – Base Channel Floor Anchor Bolt Locations ...................................... 21
Figure 10 – Base Channel Mounting Hardware ................................................... 22
Figure 11 – Top Anchor Hard-Point Locations ..................................................... 23
Figure 12 – Top Anchor Mounting Hardware ....................................................... 23
Figure 13 – Switchboard Base Channels ............................................................. 24
Figure 14 – Proper Orientation of U-shaped Splice Connector ........................... 25
Figure 15 – Ground Bus Splice Connection ......................................................... 25
Figure 16 – Series 2 Ground Bus Splice Connection .......................................... 25
Figure 17 – Grounding Electrode Connector ....................................................... 26
Figure 18 – Main Bonding Jumper ....................................................................... 27
Figure 19 – Series 2 Main Bonding Jumper ......................................................... 27
Figure 20 – Qwik Flange Installation .................................................................... 29
Figure 21 – Qwik Flange ...................................................................................... 29
Figure 22 – Removing the Busway Dummy Flanged End ................................... 30
Figure 23 – Flanged-End Connections ................................................................ 30
Figure 24 – Reinstalling the 1/2-In. (13 mm) Hardware ....................................... 31
Figure 25 – Cable Restraint Example .................................................................. 33
Figure 26 – Wrapping Cables (neutral cables not shown) ................................... 34
Figure 27 – Wrapping the Space Between Cables .............................................. 34
Figure 28 – Finish Wrapping the Space Between Cables ................................... 35
Figure 30 – Type BP Bolt-Loc Fusible Switch ...................................................... 42
Figure 31 – PowerPact™ R-Frame Circuit Breaker ............................................. 43