UM2469 Rev 1 51/59
UM2469 Pmod™ and STMod+ schematic table
58
Appendix C Pmod™ and STMod+ schematic table
The Table 18 gives the description of the signals available on the STMod+ connector. It also
shows which signal is shared with other board connectors (such as Pmod™ or Arduino Uno
V3). A switch controlled by software is present to select which function is used (using PI10
and PH15 PIOs). Analog signals are in brackets [xxx]. The I
2
C bus is shared with the
Arduino Uno V3 connectors. It is recommended to check the device slave address when
adding it to the bus. Refer to the following list of acronyms before reading the
Table 18:
• RTS7 stands for USART7_RTS
• ADC2.4 stands for ADC_2_IN4
• T8.4 stands for TIM_8_CH4
• MOSI5 stands for SPI_5_MOSI
To Next Page
Loading...
