Memory and SetupST700 Dash Display System
48
tance. This will appear either in feet or in metres, according to the
settings you make for WSPD Input Measurement Units (page 54).
Press and turn the rotary control to adjust the Split 1 distance.
Release the control to set the Split 1 distance at the displayed value.
Turn the rotary control clockwise and then follow the procedure de-
scribed above to set the Split 2 distance. Note that the Split 2 distance
cannot be less than the Split 1 distance.
Turn the rotary control clockwise and then press it to return the dis-
play to show ‘Split Timing’.
❑ Acceleration timing—Turn the rotary control clockwise until the
display shows ‘Accel/Decel Timing’. Press the rotary control briefly
to show the current setting for the acceleration starting speed. Press
and turn the rotary control to alter this setting. Release the control
to set the acceleration start speed at the displayed value.
Turn the rotary control clockwise to show the current setting for the
acceleration end speed. Press and turn the control to adjust this
speed. Release the control to set the acceleration end speed at the
displayed value. The system measures deceleration timing if the
starting speed setpoint is higher than the end speed setpoint. If you
set the start speed and the end speed to be the same, timing is disa-
bled. Set the speed in the same units used to display speed
measurements—MPH or km/h.
The ST700 Dash Display System will measure the time that it takes
for the vehicle to accelerate or decelerate through the set speed
To Next Page
Loading...