Stack ST700 - Page 53

To Next Page

To Previous Page

ST700 Dash Display SystemMemory and Setup

range. This information will be available in the memory review dis-

play, described on page 45. It will also appear in a pop–up message

if you have selected this function as described below.

Turn the rotary control clockwise to show the current status of the

acceleration timing pop–up. Press and turn the rotary control to en-

able or disable the pop–up. With the pop–up enabled, as soon as the

vehicle passes the end speed set point the display will change to

show the time taken to accelerate or decelerate through the set speed

range. With the pop–up disabled, the display will not show this in-

formation.

Turn the rotary control clockwise to show the current status of the

distance timing pop–up. Press and turn the rotary control to enable

or disable the pop–up. With the pop–up enabled, as soon as the ve-

hicle passes the quarter mile distance after moving from a standstill,

the display will switch to show the time taken to cover this distance.

With the pop–up disabled, the display will not show this informa-

tion. This measurement is available in the memory review display.

Turn the rotary control clockwise and then press it to return the dis-

play to show ‘Accel/Decel Timing’.

❑ Pop–up Settings—Turn the rotary control clockwise until the dis-

play shows ‘Popup time’. Press the control briefly to show the cur-

rent setting for the pop–up time. This is the time that any pop–up

will remain on display until it times out. Press and turn the control

to adjust the setting. Note that a setting of zero will disable all pop–