Memory and SetupST700 Dash Display System
54
ups when the engine speed is below this setting. This is to prevent
the occurrence of alarm pop–ups when the engine starts and meas-
ured conditions such as the oil pressure will be low for a short peri-
od. Press and turn the rotary control to adjust the gate RPM setting.
Input level—Press and turn the rotary control to set the system for
a high level or a low level signal for the engine speed input. Your
choice will depend on the source of the signal. Typically the setting
will be ‘high’ if the signal comes from a coil or a magneto, and ‘low’
if it comes from an ECU ‘tacho’ output.
❑ WSPD Input (wheel speed)—Press the control briefly to see the cur-
rent setting for the pulses that the wheel speed sensor detects for
each wheel rotation. Press and turn the rotary control to adjust this
setting, which will depend on the specific installation details. Refer
to page 21 for instructions to install the wheel speed sensor.
Meas units—Press and turn the control to set the ST700 Dash Dis-
play System to measure in metric units or in imperial units. This set-
ting affect the measurement units to set the split timing distances
(either in feet or metres) described on page 39, and the wheel diam-
eter setting (in inches or millimetres) described below. It does NOT
affect the units used to display speed or odometer distance, which
depend on the choice you make under ‘Speed & Odo’ described on
page 56.
Wheel circ—Press and turn the rotary control to adjust the setting of
the wheel circumference. The ST700 Dash Display System uses this
To Next Page
Loading...