Error! Main Document Only.Chapter 5. Installing the Display System STACK ST8100 Display System
30 Users Guide
Temperature sensorsTemperature sensors
The Display System is supplied with two each of one of the following
types of temperature sensor: Stack ST 760, ST761, ST762, ST763, or
ST764:
The ST760 temperature sensor has two
terminals and a 1/8" BSP taper thread.
The ST761 temperature sensor (not normally
used) has an M14 x 1.5 thread.
The ST762 temperature sensor has an M10 x 1
thread (UK, EC versions).
The ST763 temperature sensor has one
terminal and a 1/8" NPTF thread (U.S. version,
not normally used). It makes its earth contact
through its screw thread.
The ST764 temperature sensor has two
terminals and a 1/8" NPTF thread (U.S.
version)
Each type of sensor can be used for monitoring
both oil temperature and water temperature.
If you find that you have a sensor with an
incorrect thread, please return it to Stack for
replacement.
Fitting the temperature sensorsFitting the temperature sensors
Mount each temperature sensor directly in the
appropriate fluid line. Screw the sensor into a
suitable mounting boss, so that its end lies in the middle of the flow of
fluid.
• Position the sensors and their cables as far as possible from sources of
intense heat and from the ignition HT leads.
ST763
ST760
ST761
ST762 or
ST764
To Next Page
Loading...