Stack ST8100 User Manual

STACK ST8100 Display System Error! Main Document Only.Chapter 5. Installing the Display System
Users Guide 33
Lap timing sensorLap timing sensor (optional) (optional)
The lap timing sensor is actuated by an infra-red beacon positioned at
the side of the circuit. The sensor is fixed to a rigid bracket mounted at a
convenient position on the outside of the vehicle where it is able to detect
the signals from the beacon.
It is secured by two nuts with an M18 x 1 mm thread.
This sensor must be positioned horizontally and square to the axis of the
vehicle. In order to detect the signals from the beacon, it must be sighted
outside the vehicle. It should, if possible, be positioned so that other
vehicles that are being overtaken (or are overtaking) at the moment your
vehicle passes the beacon do not block the signal.
Note that after detecting a signal, the system does not recognise any
further signals from beacons for a period of ten seconds.

Stack ST8100 Specifications

General

Brand	Stack
Model	ST8100
Category	Monitor
Language	English