5.3.4. Power consumption settings
In the Application Settings Device configuration -> Power Management
Power consumption settings window
Current reduction enabled - activates the reduced energy consumption mode.
Current in hold mode - it determines the current in the hold mode in % of the nominal value. Value range: 0 .. 100%.
Current reduction delay - parameter determines the delay between switching to the STOP mode and power reduction activation.
It is measured in milliseconds. Value range: 0 .. 65535 ms.
Power off when stop - it activates the function that deenergized the motor windings after switching to the STOP state.
Power off delay - parameter determines the delay in seconds between switching to the STOP mode and motor power-off. Value
range: 0 .. 65535.
Jerk free - activates the current smoothing function to eliminate the motor vibration.
Current set time - parameter determines the time for jerk free current setting in milliseconds. Value range: 0 .. 65535 ms.
Detailed description of these parameters see in the Power control section.
To Next Page
Loading...