4.3.10. Saving the parameters in the controller flash memory
The controller provides an option to save all its parameters into the non-volatile memory. The configuration is restored when the
controller is powered on, after that the controller itself is instantly ready for operation. The stage requires no new adjustment every
time the power is on. The controller stores its user-defined name which is useful for its further identification.
The non-volatile memory stores all the actual operating parameters of the controller related to Device configuration section of XiLab
settings menu. Either Save to flash button of XiLab program or command_save_settings function are used for it (see the
Programming guide chapter).
All the configuration parameters can get restored to controller's RAM from the non-volatile memory, not only when the power is turned
on but also by clicking the Restore from flash button of XiLab program which provides the access to the data saved in the flash
memory. Internally it uses command_read_settings function (see the Programming guide chapter). The restored settings become
active instantly and all the modules of the controller get re-initialized.
To Next Page
Loading...