Star Micronics TUP500 series - 14.3. MSW2

TUP500 Series Product Specifications
14-5
14.3. MSW2
Bit Function OFF/”0” ON/”1” Emulation Note
SL SP EP
F
E
D
C 180˚ invertion function Invalid Valid ○ × ○ *4
B
A
9
8 Print Startup Control Page Units Line Units ○ × ○ *3
7
6
5 Print Speed (See table below) ○ ○ ○ *2
4 Print Speed (See table below) ○ ○ ○ *2
3
2 Print Density (See table below) ○ ○ ○ *1
1 Print Density (See table below) ○ ○ ○ *1
0
Print Density (See table below) ○ ○ ○ *1
*1) Printing Density
Print density settings are valid for single and 2-color modes and Double Resolution mode.
Low Peak Current mode is invalid for print density settings.
3n MSW2-2 MSW2-1 MSW2-0 Print Density
Single-color Mode 2-color Mode
Double Resolution Mode
“0” 0 0 0 1.0 1.0
“1” 0 0 1 1.1 1.0
“2” 0 1 0 1.2 1.2
“3” 0 1 1 1.3 1.2
“4” 1 0 0 1.0 1.0
“5” 1 0 1 0.9 1.0
“6” 1 1 0 0.8 0.8
“7” 1 1 1 0.7 0.8
*2) Printing Speed
Print speed settings are possible only for single color mode.
They are invalid for 2-color mode. (The print speed in 2-color mode is a maximum of 80mm/sec.)
Low Peak Current mode is invalid for print density settings. (When in Low Peak Current mode, print speed: 150 mm/
sec.)
Print speed settings are invalid for Double Resolution mode. (The print speed in Double Resolution mode is a
maximum of 120 mm/sec.)
n MSW2-5 MSW2-4 Single Color Printing Mode
“0” 0 0 Standard: Max. 180 mm/sec
“1”
0
1 Mid. Speed: Max. 120 mm/sec
“2” 1 0 Low Speed: Max. 80 mm/sec
“3” 1 1 High Speed: Max. 220 mm/sec
However, when the print region setting is less than 72 mm, the maximum is 180 mm/sec.
See section 3.1 Print Specications for details on other restrictions.