TUP500 Series Product Specifications 5-4
5.3. Vibration/Falling Shocks
5.3.1. Vibration Tests (When Packing)
With the following testing conditions, must be no visual or operational problems externally or internally after ap-
plying vibration.
Vibration Direction XYZ
Vibration Frequency: 7Hz to 100Hz
Sweep Time: Logarithmic Frequency Sweep Rate: Reciprocal at 5 minutes
Vibration Acceleration Speed: 1.5 G (Constant)
Printing Time One hour (Total 3 hours)
Packed Status Minimum Packing Status
5.3.2. Drop Tests (When Packing)
With the following testing conditions, must be no visual or operational problems externally or internally after ap-
plying vibration.
Height of Drop 80cm
Direction of Drop 1 angle; 3 corners; 6 surfaces
Number of Drops Once each time (Total of 10 drops)
Packed Status Minimum Packing Status
5.3.3. Impact Tests (When Not Packing)
Must be no visual or operational problems externally or internally when not operating, after dropping.
Height of Drop 5cm
Direction of Drop 4 Sides, Side Support
Number of Drops 1 time each
5.4. Noise
Measured Rating: ANSI 1.29
TUP592-24 Approx. 58 dB
TUP542-24 Approx. 58 dB
5.5. Dust
There is no affect on operation in a normal office environment.
5.6. Installation Posture
Printer Setup Posture Horizontal layout
Tolerance Range of Setup Posture ±3°
Notes:
1. The printer was designed to conditions for a horizontal layout. If the printer I used when
setup outside of the tolerance range, paper conveyance problems will occur and paper
jams will occur.
To Next Page
Loading...
