Star Micronics TUP500 series - Black Mark Specifications

TUP500 Series Product Specifications
3-13
Notes:
1. Ex-factory default settings are for 72 mm.
2. Values relating to the left/right margins above are not guaranteed.
3. Operating the printer with the values designated by the asterisk cannot ensure the rec-
ommended left/right margins of more than 4 mm. The print region may be outside of the
paper width.
(11) Other Precautions: See below
1) The coloring side should be the outside portion of the roll paper.
2) Do not use inner wrapped rolls.
3) The trailing edge should not be folded.
4) Do not glue to fasten to roll paper and shaft core.
3.3.2. Black Mark Specifications
The following describes the recommended black mark specifications for printers that use the paper out detector
as the black mark detector.
(1) Black Mark Pitch (Dimension A)
Black mark pitch can be set to the following range.
CONFIGURA-
TION
Black Mark Pitch (Dimen-
sion A)
TUP592 75 to 300 mm
TUP542 45 to 300 mm

㻌
Prin ting
D irection
Min. 15 (mm)
Backside of Paper
Print Surface
is Backside
Print Range
㻝㻌㻗㻝㻙㻜㻚㻤㻔㼙㼙㻕㻌
㻌
5
±1 (mm)
㻌
Cutting
Position
B (mm)
A (mm)
C (mm)
㻌
㻌
Fig . 3.3.2 . B lack M ark S p e cificatio ns
25 ±2 (mm)