Star Micronics TUP500 series - 15.3. Error Specifications

TUP500 Series Product Specifications 15-4
15.3. Error Specifications
15.3.1. Auto-recovery Error
This error automatically cancels E errors by varying the status internally on the printer.
Error LED Cause of Error How to Cancel Error
LED1 (Green) LED2 (Red)
Head High
Temperature
Stopped Printing
Flashing Cycle
for 1.0 seconds
OFF Head Thermistor High Temperature (70ºC) Automatic recovery when temperature
drops (65ºC)
15.3.2. Recoverable Errors
This error cancels errors while maintaining the printer’s status, by executing a determined error canceling operation.
Error LED Cause of Error How to Cancel Error
LED1
(Green)
LED2
(Red)
NE Error ON Flashing Cycle
for 4.0 seconds
Low in paper Replace the paper
Cover Open Error ON ON Cover Open 1. Remove paper in the presenter and in the printer.
2. Replace Paper
3-1) Manual Operation
3-1-1 Set the paper and close the cover.
3-1-2) Sw2 Push
3-2) Auto-loading Operation
3-2-1) Close the cover
3-2-2) Insert paper into the printer’s paper supply inlet.
3-2-3) Auto-loading Operation Startup
4) Online Recovery Operation Execution
PE Error ON Flashing Cycle
for 1.0 seconds
Paper Out Detection 1. Open the cover, remove paper in the presenter and in the
printer.
2. Replace Paper
3-1) Manual Operation
3-1-1 Set the paper and close the cover.
3-1-2) Sw2 Push
3-2) Auto-loading Operation
3-2-1) Close the cover
3-2-2) Insert paper into the printer’s paper supply inlet.
3-2-3) Auto-loading Operation Startup
4) Online Recovery Operation Execution
BM Error ON Flashing Cycle
for 1.0 seconds
Black Mark Paper Size Error
(White detected over 400 mm long)
Replace Black Mark Paper
Readjust with Sensor Adjustment Mode