TUP500 Series Product Specifications
3-19
(2) Roll Paper Holder Unit Adjustment
Fig. 3.6.2.2 is a reference for the roll paper holder unit roll paper shaft. Adjust or mount the roll pa-
per holder unit for the core diameter and width of the paper you intend to use. Also, the reference
pitch is 2 mm. Therefore, to handle any type of paper, position the roll paper holder (fastened side)
according to this reference.
Supports 82.5 mm paper width
See Fig. 3.6.2.2.B. for the roll paper holder (fastening side) setting position to handle paper widths
of 82.5 mm.
Position the edge of the roll paper holder (fastened side) onto the central position of the reference d
position.
Supports 79.5mm paper width
See Fig. 3.6.2.2.C. for the roll paper holder (fastening side) setting position to handle paper widths
of 79.5 mm.
Position the edge of the roll paper holder onto the central position of the reference d position.
Fig. 3.6.2.2.A.
Scale d
Scale b
Scale a
Scale c
1 (Scale Pitch)
Fig. 3.6.2.2.B .
Position the roll paper holder edge on the scale c
Fig. 3.6.2.2 .C .
Position the roll paper holder edge on the scale c
To Next Page
Loading...
