Star Micronics TUP500 series - Page 3

5.4. Noise 5-4
5.5. Dust 5-4
5.6. Installation Posture 5-4
6. RELATED RULES 6-1
6.1. Compatible Specifications 6-1
6.2. Environmental Ordinances 6-1
7. USAGE EXAMPLE (LAYOUT EXAMPLE) 7-1
7.1. Control Board Layout 7-1
7.1.1. Control Board Layout 1 7-1
7.1.2. Control Board Layout 2 7-1
7.2. Layout of the Large Roll Paper Holder Unit (RUH-T500, Optional) 7-1
7.2.1. Horizontal Type Layout 7-2
7.2.2. Vertical Type Layout 7-2
8. PRINTER SETUP 8-1
8.1. Mounting the Units 8-1
8.1.1. Mounting the Printer 8-1
8.1.2. Layout of the Large Diameter Roll Paper Holder Unit (RUH-T500, Optional) 8-1
8.1.3. Layout of the Printer and Large Diameter Roll Paper Holder Unit 8-1
8.2. Assembly of the Large Roll Paper Holder Unit (RUH-T500, Optional) 8-3
8.2.1. Horizontal Type Layout Assembly 8-3
8.2.2. Vertical Type Layout Assembly 8-3
8.3. Fastening the Friction Spring 8-13
8.3.1. Using the Spring Base 8-13
8.3.2. When Not Using the Spring Base 8-16
8.4. Adjusting the Near-end Sensor Unit 8-19
8.4.1. Adjusting in the Roll Paper Width Direction 8-19
8.4.2. Adjusting in the Roll Paper Diameter Direction 8-19
9. HANDLING THE PRINTER UNIT 9-1
9.1. How to Set the Roll Paper 9-1
9.2. Maintenance Method 9-6
9.2.1. Periodic Maintenance 9-6
9.2.2. Handling Paper Jams 9-6
9.2.3. Releasing a Locked Cutter 9-7
9.3. Precautions for Designing 9-8
9.4. Precautions for Handling 9-10
9.5. Precautions Concerning Safety 9-12
9.6. Voluntary Control for Electromagnetic Interference 9-12
10. CIRCUIT GENERAL SPECIFICATIONS 10-1
10.1. General Specifications 10-1
11. CIRCUIT CONFIGURATION 11-1
11.1. Block Diagram 11-1
11.2. Description of Units 11-2
12. CIRCUIT CONNECTION SPECIFICATIONS 12-1
12.1. Connector Specifications and Signal Names 12-1
12.1.1. Control PCB 12-1
12.1.2. Sub-board 12-7
12.1.3. Operation Board 12-8
12.2. External Drawing 12-9
12.2.1. Main Board 12-9
12.2.2. Sub-board 12-10
12.2.3. Operation Board 12-11