TUP500 Series Product Specifications 8-20
Fig. 8.4.2.B. shows the scale on the optional large diameter roll paper holder unit (RHU-
T500) frame.
Also, the following explains two ways as representative examples to adjust the position.
[Ex. 1] When using a Ø25.4 paper core inner diameter on the horizontally layout of item 7.2.1.
Adjust the central position of the notch on the near-end sensor to the scale a shown in
Fig. 8.5.2.B.
[Ex. 2] When using a Ø25.4 paper core inner diameter on the vertical layout of item 7.2.2.
Adjust the central position of the notch on the near-end sensor to the scale g shown in
Fig. 8.5.2.B.
To Next Page
Loading...
