13
1
Remove the four screws from the tread display
as shown.
(Screws are no longer needed)
Treadmill Installation Instructions
Tools required for treadmill (not supplied):
• 5mm or 3/16 Allen wrench (Crossbow and clamp screws)
• 1/8 “ Allen wrench (Neck screws)
• #2 Phillips Screwdriver (Wings screws)
• 7/16” or 11MM open end wrench (Crossbow screws)
CAUTION: UNPLUG THE TREADMILL BEFORE PROCEEDING.
All Treadmills
To Next Page
Loading...
