Bike, Crosstrainer, Stepper Wires
• The wires will exit the bracket down onto the fitness product neck.
• Do not use tie–wraps around the fitness product neck. Use the wire
management strip instead.
•
If not already attached, you will need to adhere the wire management to the
fitness equipment during your installation. Please see wire management section
in this manual.
• Hide the video and power cord within the rubber strip and Velcro to the neck.
• The mating side of the Velcro will be attached to the fitness equipment by using
the double stick backing of the Velcro provided.
• Tread Wires
• Do not use tie–wraps around the fitness product neck.
•
The wires will exit upward from the bottom of the bracket and toward the tread
display console.
•
The tread product does not have a wire management strip like the other
products.
• Reaching up and under the tread display, you will feel the top of the treadmill
product neck. This neck is hollow and makes a great location to run all the
installed wires down to the floor.
• Use a fish tape, or other similar wire pulling device to guide the wires through
the neck.
A/V Installer’s Guide (cont.)
Bike, CrossTrainer, Stepper and Pro Tread
To Next Page
Loading...
