Please bring the treadmill up to a full incline to verify the slack required for
treadmill products.
•
Some equipment requires a long ER power cord than other products. The
following table shows the minimum length of DC side power cord:
• Verify the installed wires have enough slack to allow the TV to tilt up and down
without putting tight tension on the wires.
• The Bike, Cross Trainer and Stepper equipment requires the use of a wire
management strip that runs down the neck. This strip consists of a rubber
extrusion piece with Velcro attached. The treadmill product does not require the
use of a wire management.
A/V Installer’s Guide (cont.)
Bike, CrossTrainer, Stepper and Pro Tread
Product DC side cord length notes
Bike – Upright 100 inches | 254 cm
Bike – Recumbent 97 inches | 246 cm
Cross Trainer 107 inches | 272 cm
Stepper 112 inches | 283 cm
Treadmill 130 inches | 330 cm
The treadmill has an
incline feature. Make
sure to bring the tread
to full incline to verify
enough cord slack is
available.
To Next Page
Loading...
