Staubli Cam Motion 1781 - 3 - SAFETY; 3.1 - GENERAL SAFETY INSTRUCTIONS; 3.2 - OPERATING SAFETY INSTRUCTIONS; 3.3

To Next Page

To Previous Page

3 - SAFETY TZS15-SCT001.1

3.1 - GENERAL SAFETY INSTRUCTIONS TMS15-SCT002.1

All actions performed on the cam motions must be carried out in strict compliance with the safety

regulations currently in force in the country concerned.

IMPERATIVE

Only skilled and authorized persons should carry out these operations.

3.2 - OPERATING SAFETY INSTRUCTIONS TMS15-SCT004.1

Refer to the safety instructions stipulated by the weaving machine manufacturer.

3.3 - MAINTENANCE SAFETY INSTRUCTIONS TMS15-SCT005.3

IMPERATIVE

Maintenance must be performed by technically-proficient and certified personnel.

Wear protective gloves when performing maintenance operations.

All adjustments, testing and maintenance operations mentioned in this manual must be carried

out while the weaving machine is stopped.

IMPERATIVE

Disconnect the electrical power supply to prevent any untimely start-up.

However, the operations that require the weaving machine to be turned on, only slow or

step operation is authorized.

The oil is very hot during operation:

- Do not uncover the cam motion if the inside temperature is greater than 40°C.

- Allow the cam motion to cool down before removing the cover.

- Wear protective gloves before opening and when performing oil change operations.

3 - Safety

Staubli Cam Motion 1781 - 3 - SAFETY; 3.1 - GENERAL SAFETY INSTRUCTIONS; 3.2 - OPERATING SAFETY INSTRUCTIONS; 3.3 - MAINTENANCE SAFETY INSTRUCTIONS