Staubli Cam Motion 1781 - 6.2.7 - LUBRICATION OF CLAMPING LOOP JOINTS

To Next Page

To Previous Page

- Remove all fibres and particles from the drive shaft (2).

ATTENTION

The accumulation of fibres and particles may damage the seal and the bearing (1).

6.2.6 - CLEANING OF THE LEVERS TRM50-NDL001.2

Frequency:

- With each chain replacement without exceeding 1 months.

Procedure:

IMGT4646

- Remove all fibres and particles around the levers (1) .

ATTENTION

The accumulation of fibres and particles may cause oil leakages.

Note :

STÄUBLI recommends vacuum cleaning.

6.2.7 - LUBRICATION OF CLAMPING LOOP JOINTS TTM50-TAB012.1

Tools / Servicing materials:

- Grease gun.

- Point 1: 1 cm³ GLEITMO 585M grease (mandatory for the link joints).

6 - Maintenance