- Fill the cam motion with the required amount of new oil (See "Filling the cam motion", page
13).
ATTENTION
Oil may be topped up via the filter without shutting down the cam motion.
ATTENTION
While running, the level should be located at the center of the sight glass, as indicated
on the label.
IMGT3967
6.2.5 - CLEAN THE DRIVE SHAFT TRM50-NAC001.3
Frequency:
- With each warp change without exceeding 1 month.
Procedure:
IMGT3995
6 - Maintenance
1781 B1 DRC10 © Stäubli 2013 – F.143.489.04-C 49/62
To Next Page
Loading...