Staubli Cam Motion 1781 - 5.3

To Next Page

To Previous Page

- The number of levers in movement.

ATTENTION

Each time one of these parameters is changed, the speed of the weaving machine must

be checked to ensure that it is compatible with the manufacturer's data.

ATTENTION

Never exceed the speeds recommended by the manufacturer of the weaving machine on

which the cam motion is installed.

All excessive speed shall be considered as an operating fault or equipment overload and

the consequences are therefore not covered under the guarantee.

5.3 - SHED ADJUSTMENT TTI20-COR001.3

(M7-22Nm)

IMGT3972

The shed adjustment is performed by adjusting the position of the clamping loop (3) on the le-

ver (1). This position is determined by dimension A provided by the weaving machine manufactu-

rer.

Procedure:

- Loosen screw (1).

- Adjust the position of the clamping hoop.

- Tighten the screw (1) to the recommended torque value.

5 - Operation

Staubli Cam Motion 1781 - 5.3 - SHED ADJUSTMENT