Staubli Cam Motion 1781 - 4.1.3 - CHECK THE OPERATING CONDITIONS; 4.2

To Next Page

To Previous Page

4.1.3 - CHECK THE OPERATING CONDITIONS TMU35-CFO001.1

The maximum speed of the cam motion is a function several parameters:

- Cam profile.

- Frame travel.

- Maximum reed space.

- The weight of the frames.

- The weight of the heddles.

- The number of frame links.

- The weave.

- The number of levers in movement.

ATTENTION

Each time one of these parameters is changed, the speed of the weaving machine must

be checked to ensure that it is compatible with the manufacturer's data.

ATTENTION

Never exceed the speeds recommended by the manufacturer of the weaving machine on

which the cam motion is installed.

All excessive speed shall be considered as an operating fault or equipment overload and

the consequences are therefore not covered under the guarantee.

4.2 - START-UP TMU35-MIR001.1

4.2.1 - CHECK OIL LEVEL TMU35-MIR002.1

(See "Check oil level", page 43)

4.2.2 - FIRST OIL CHANGE TMU35-MIR003.1

After 500 hours of operation (3 weeks maximum).

(See "Programmed maintenance", page 61)

(See "Table of equivalent oils and greases", page 41)

4 - First use

Staubli Cam Motion 1781 - 4.1.3 - CHECK THE OPERATING CONDITIONS; 4.2 - START-UP