Staubli Cam Motion 1781 - 5.7.2 - INDEXING PREPARATION

- Position the rods (2) on the indexing plate (1).
- Place as many rods (2) as there are picks in the ratio:
example: cam
4
1
(5 satin, warp effect). Use five rods, position one at point n°1 and the
other fours at the points numbered 5.
Note :
Check that the ratio of the drive gear and pinion (bevel wheel and bevel gear) corresponds
to the weave ratio of the cams.
5.7.2.2 - Installation of the cam shaft on the indexing plate TMU35-IND007.1
A
B
5
5
5
5
1
1
2
3
4
IMGT1440
- Equip the indexing plate with a STÄUBLI adapter No. F.130.813.00.
- Place the equipped cam shaft (1) on the indexing plate:
• Bearing (4).
• Rings (3) according to the position of the first lifting unit.
• Shouldered spacer (2).
ATTENTION
For the unused levers:
- (See "Immobilised lifting units", page 19).
ATTENTION
- Only cams with same repeat length are to be mounted on the same shaft. example:
cam
2
2
, with cam
3
1
.
5 - Operation
32/62 © Stäubli 2013 – F.143.489.04-C 1781 B1 DRC10