Staubli Cam Motion 1781 - Page 8

Lubrication with oil
Housing
Maximum number of lifting units that can be installed in the cam motion.
Open shed position
Position of the cam motion enabling the frames to be placed in movement depending
on whether the weave is in the high or low position. This position corresponds to the
stop position of the frames, enabling the weft to be inserted.
Closed shed position
Position of the cam motion enabling the fames to be placed in movement at cross-shed
position. The other frames remain in high or low position.
Levelling of the harness frames
Position of the cam motion enabling all of the frames to be placed in cross-shed
position using the leveller.
1 - Foreword
8/62 © Stäubli 2013 – F.143.489.04-C 1781 B1 DRC10