Steinbach Active Balls 50 - Preparation Steps; Initial Device Cleaning; Choosing Installation Location

NOTICE!
There is a higher risk of damage to the device if it is stored or
transported without the packaging.
- Do not dispose of the packaging.
- In the case of damage, substute the packaging with an at least
similar box.
Checking the delivery for completeness and damage
1. Open the packaging carefully.
2. Take all parts out of the packaging.
3. Check the completeness of the delivery.
4. Check the delivery for damage.
Preparation
Initial cleaning of the device
1. Remove the packaging materials and all protecve foils if present.
2. Clean all parts of the package content as described in the "Cleaning" secon.
The device has been cleaned and is ready for use.
Choosing the location
The lter system is suciently protected against the penetraon of water
and foreign objects. We nonetheless recommend choosing a site that is
protected from the weather.
- Posion the lter system between the sucon opening and the injecon nozzle.
- Ensure sucient distance to the pool wall so that the lter system cannot be used as
an aid for entering the pool.
- Make sure that the maximum distance of 3 meters to the pool is not exceeded.
- Install the lter system on a solid base such as a large concrete pao stone. Use a
spirit level
33
to make sure it is level.
Product dimensions:
41