Steinbach Active Balls 50 - Connecting the Suction Line; Connecting the Return Line; Preparing the Filter System

Connecting the suction line
Connecting the suction line with the self-fastening hose
- When using self-fastening hoses Ø 32 / 38 mm.
1. Screw a hose adapter
12
clockwise
onto the prelter cover
11
.
2. Make sure that water from the supply
or drain line does not ow into the
pool.
3. Push the hose end onto the hose
adapter and use the hose clamps to x
the hose in place.
The sucon line is connected.
Connecting the return line
Connecting the return line
When using push-on hoses.
1. Push one hose end onto the connecon for the return line
27
on the lter cover
1
.
2. Connect the second end to the connecon on the injecon nozzle of the pool.
The return line
27
is connected.
Preparing the filter system
1. Remove the stopper on the sucon line if applicable.
2. Check that the sucon line is free and then open the shut-o valve on the sucon
line.
The lter system lls automacally with water because it is below the water level.
3. Let the lter vessel ll completely with water.
4. Bleed the lter system. Open the prelter cover
11
on the pump slightly by loosening
the threaded ring
13
unl water ows from the prelter cover.
5. Let the prelter cover ll completely with water.
6. Check the lter system and the connecons for leaks.
In the case of leaks, wrap extra Teon tape around the aected connecons.
13
12
11
49