Steinbach Active Balls 50 - Operation Guide; Pump Operation; Care Instructions

Operation
CAUTION!
Risk of injury!
A damaged device or damaged accessories may cause injuries.
- Check the device and the accessories (see secon "Tesng").
Pump operation
Informaon on how the mer funcon works can be found in the "How the mer
works" secon
Starting the pump operation
1. Connect the pump's power plug to the power supply.
The running me display is lit. If a baery is inserted, the last selected running me is
displayed.
2. Press the mer buon
29
several mes unl the LED of the desired running me is
lit.
3. Press the ON/OFF buon
30
to switch on the pump
10
.
The pump will now run nonstop for the selected running me. The mer funcon
acvates the pump again at the same me on the following day.
The pump is running. Listen to the pump to check for any unusual noises. If there is air in
the system, bleed it again.
Stopping the pump operation
To stop the pump operaon, press the ON/OFF buon
30
. The mer funcon can be
deacvated only by disconnecng the pump from the power supply.
Care instructions
The lter system cannot lter out algae, bacteria and other microorganisms.
- Use special water care substances to prevent and remove these to ensure
hygienically clean water.
- Consult an expert and observe the dosage.
Maintenance
Exchanging the filter medium
The Steinbach lter balls should be exchanged every 2 to 3 years, depending
on the operang period and the amount of dirt on the device.
50